Paver Coat – 1K (Water Based) Acrylic

Product benefits:

1. High exterior durability
2.  Self-priming
3.  Fast drying and Cure
4.  Low dirt pickup / Easy to clean
5.  Excellent Flow & Leveling

Surface Preparation:

The surface to be applied needs to be clean and free from dust, dirt, oil or greasy material, laitance, organic debris, etc. If any, it should be removed using wire brushing or power tool cleaning and clean the surface using fresh water and appropriate surface cleaners.

Algae or fungus needs to be cleaned using house hold bleach and wash with fresh water later. Any cracks or crevices present should be filled with suitable filling compounds before application. Any dampness issues need to be arrested appropriately before application.

After cleaning, sand the surface to remove any smoothness or glossy areas using wire brush or power tool sanding. Wash with fresh water to remove the dust, allow the surface to dry.

New concrete, masonry or plaster: The new concrete should have matured at least 30 days in ambient conditions for application of Sheenlac Paver coat -1 K WB ACRYLIC.

Coating over existing aged coating: In ideal scenario the aged existing coating should be removed before application of Sheenlac Paver coat-1 K WB ACRYLIC. If the situations where existing coating cannot be removed, the adhesion of the existing coating on to the substrate needs to be assessed properly and the loose flaky materials need to be removed using appropriate methods before applying Sheenlac Paver coat-1 K WB ACRYLIC. In the event where adhesion fail, the existing coating needs to be completely removed before applying Sheenlac Paver coat-1 K WB ACRYLIC.

Application Data:

1. Stir the paint thoroughly. Use potable water for thinning and don’t over thin the paint more than the recommended levels.
2. Apply a self-priming coat of Sheenlac Paver coat -1 K WB ACRYLIC, by diluting with 30-50% water. Allow it to dry for minimum 5-6 hours (25 Deg C/ 50% RH)
3. Apply further coat of Sheenlac Paver coat -1 K WB ACRYLIC at 10- 20% dilution using standard brush, roller or spray.
4. One more optional coat may be applied depending on the hiding and colour requirements.Note: This product is not intended to use for heavy motor vehicle traffic, water-logging, or immersion services and where acid/alkali spillages are likely. Care should be taken when moving heavy motor vehicle, portable cranes etc. over the coated surface.